Click or scroll to zoom
Tap or pinch to zoom
Click or scroll to zoom
Tap or pinch to zoom
Flexbar® Sensing-Saf-Start®
$198.00 USD
SKU 17023
The inexpensive solution to OSHA.
Anti-automatic restart protection without the high cost of magnetic motor starters.
THIS IS A MANDATORY OSHA SAFETY REQUIREMENT.
Product Types
Description
Now available in multiple extension cord style or hard wire versions.
Operating Characteristics
When a SENSING-SAF-START® is installed on any equipment and there is an electrical power interruption to the equipment, the SENSING-SAF-START® will open the circuit so when the power source is restored, the SENSING-SAF-START® will prevent the equipment from restarting. The SENSING-SAF-START® will not reset until the equipment switch has been turned "off". There is a sensing circuit within the new SENSING-SAF-START® that sends a signal up to the equipment switch to see if it is in the "on" position. If the switch is still "on", the SENSING-SAF-START® sounds a warning buzz when the reset button is depressed, and it will not close the circuit until the equipment switch is turned "off". Only then, the SENSING-SAF-START® will close the circuit , so the equipment will operate again.
Installation
Installs in minutes on:
- drill presses
- disc sanders
- tool grinders
- table saws
- cut-off machines
- power hacksaws
- band saws
- belt sanders
- small milling machines
- radial arm saws
The inexpensive solution to OSHA.
Anti-automatic restart protection without the high cost of magnetic motor starters.
THIS IS A MANDATORY OSHA SAFETY REQUIREMENT.
- Product Types
- Description
-
Installation
Product Types
Description
Now available in multiple extension cord style or hard wire versions.
Operating Characteristics
When a SENSING-SAF-START® is installed on any equipment and there is an electrical power interruption to the equipment, the SENSING-SAF-START® will open the circuit so when the power source is restored, the SENSING-SAF-START® will prevent the equipment from restarting. The SENSING-SAF-START® will not reset until the equipment switch has been turned "off". There is a sensing circuit within the new SENSING-SAF-START® that sends a signal up to the equipment switch to see if it is in the "on" position. If the switch is still "on", the SENSING-SAF-START® sounds a warning buzz when the reset button is depressed, and it will not close the circuit until the equipment switch is turned "off". Only then, the SENSING-SAF-START® will close the circuit , so the equipment will operate again.
Installation
Installs in minutes on:
- drill presses
- disc sanders
- tool grinders
- table saws
- cut-off machines
- power hacksaws
- band saws
- belt sanders
- small milling machines
- radial arm saws
Installation
Installs in minutes on:
- drill presses
- disc sanders
- tool grinders
- table saws
- cut-off machines
- power hacksaws
- band saws
- belt sanders
- small milling machines
- radial arm saws