Triga-Bore

Description Sets Available covering a measuring range: .236"/6mm to 3.937"/100mm. Sold with or without indicators. Ideal for solving internal dia...

Description Economical Basic Set includes: Pistol Grip Handle 3-Point Bore Gage Head Triga-Bore™ Stand (No. 20336) Fitted hard plastic case (with...

Description Economical Basic Set includes: Flexbar Model No. 15835 Bluetooth Electronic Indicator, 0-.5"/12.5mm range Pistol Grip Handle 3-Point B...

Triga-Bore Heads have a large measuring range and are supplied with fixed anvils eliminating operating error. 24 heads cover .236"-7.87" (6-200mm r...

Accepts head in ranges of: .236-.630" (6-16mm)  and .630-7.874" (16-200mm).

Accepts head in ranges of: .236-.630" (6-16mm)  and .630-7.874" (16-200mm).

Extension for use with gage heads. Extensions may be combined for longer gaging depths. Special length extensions available upon request.

Master Setting Ring for Flexbar Triga-Bore™ System. Sizes Available from .2912 in. to 7.6875 in.

Featuring Direct RS232C Output and Swiss SYLVAC electronics. A sophisticated non-contact linear measuring system...can be connected to any computer...

Available in 1/2" and 1" indicator sizes, .00016" or .0005" Accuracy, and .00005/0,001mm or .0005/0,01mm Reading. Smart Wireless Connection: connec...

Precise groove measurements are made easily and accurately. Application requirements for groove width minimum is .060" (1.5mm). Groove depth may no...

Spherical shaped heads are useful in deep bores where holding the bore gage straight in the bore is difficult, the spherical shapes allows only a s...

Available in two or three point thread measurement heads according to application.

Available in two or three point thread measurement heads according to application.

To design the Anvil head for Spline measurement, the following information is required: profile drawing of the Spline to be measured with full desi...

To design the Anvil head for Slot measurement, the following information is required:  Length of slot to be measured Slot Width Depth of clearance...

To design the Anvil head for Slot measurement, the following information is required:  Entry Diameter Length of Component Datum point diameter Min...

Supports Triga-Bore handle/head when not in use.